Tutorials > Report generation and publishing > Module 1: Run a prewritten report
  
Module 1: Run a prewritten report
Print or view a report from the Samples encyclopedia.
Learning objectives
After completing this lesson you will know how to run a prewritten report.
Time required
This module should take approximately 3 minutes to complete.
Prerequisites
To complete this module, you will need to have the Samples encyclopedia open. If you need directions on how to open prebuilt encyclopedias, or this encyclopedia is not attached to your server, refer to the Introduction section of this module.
Lessons in this module
Lesson: Run a prewritten report
The reporting system in System Architect provides a number of prewritten report files. Each of these report files (.rpt extension) contain a number of prewritten reports.
Next
Lesson: Run a prewritten report
See also
Introduction to report generation and publishing
Report generation and publishing