This section describes how to modify the mapping source or target of an existing data mapping.
1 In the pop-up Data Mapping editor, select the data mapping from the table on the bottom.
Note Once a mapping is selected, you could see the mapping source and the target displayed and highlighted on the top panels and proceed to edit them if required, including updating data mapping and removing data mapping.
2 Re-select the new mapping source or target or both that you want to update.
3 Click Update.
Use CTRL+Z to undo the previous operation, or CTRL+Y to redo it.
4 Click OK.
The data formatter is saved into the Transaction file and can be viewed in the Format tab of the Transaction editor.
