Editing a report in text mode

Each step below represents a different section of the report and the commands that can be used in that section.

First you must access the Edit <report name> – Text Mode dialog. From that dialog, follow these steps to edit the appropriate report block.

1 Use ID and these commands to edit the report block:

2 Use these commands to edit the Report Type Block:

3 Use these commands to edit the Local Definition Report Block:

4 Use these commands to edit the Level Specification Report Block:

5 Click Draft (see Draft dialog) to display the report output to your desktop,

click Print (see Choices for printing a report) to run the report to a printer or a file.

6 If the report contains errors, a warning dialog displays (see Text mode error).

Correct any error conditions existing in the report and run it again until all errors are corrected and report produces the desired output.

7 Click OK to close the Text Editor dialog and return to the Report dialog.

8 From the Report dialog, click OK to save the report to the open Report Definition file.